Sanus Systems ELM701 Manual download pdf (Page 13)

6901-002026 <02>

3 mm

(1/8 in.)

12 mm

(7/16 in.)

[02]

[01]

Attach Wall Plate [02] and Anti-tip Strap [01] to Wood Stud Wall

1. Locate stud. Verify the center of the stud with an awl or thin nail or use an edge to edge stud  nder.

2. Level the wall plate [02] and mark the hole locations.

3. Drill pilot holes as illustrated.

4. Tighten the lag bolts [03] only until the washers [04] are pulled  rmly against the wall plate [02].

5. Insert the strap hook (H) into the wall plate [02].

6. Rotate the strap hook (H) so that it is perpendicuar to the wall plate [02].

7. Tighten straps (S).

NOTE: If you need to move your funiture, loosen the straps and then unclip the strap hook (H) from the wall plate [02].

CAUTION:

Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:

Ù Pilot holes must be drilled to a depth of 63.5 mm (2.5 in.), using a 3mm (1/8 in.) diameter drill bit.

Ù Do not over-tighten the lag bolts [03].

Ù Any material covering the wall must not exceed 16 mm (5/8 in.).

CAUTION:

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

No comments

Sanus Systems ELM701 Manual Page 13